In Stock

REVITALIZANT EX120 for All Types of Diesel Engines




REVITALIZANT EX120 for All Types of Diesel Engines.

Designed for restoration, repair, and antiwear protection of diesel engines, including high-powered and turbocharged ones.

  • Restores friction parts of the cylinder-piston group, crank and gas distribution mechanisms and protects them from wear
  • Significantly reduces fuel consumption (up to 30% at idle)
  • Increases oil system pressure to the nominal level
  • Equalizes and increases compression in cylinders
  • Increases power of the engine, improves its acceleration capability
  • Reduces noise and vibration by 10 times;
  • Extends the service life of units by 2–3 times
  • Protects the engine from the negative effects of a cold start
  • Improves engine performance already after 50–100 km
  • Allows engine operation in case of an emergency oil leakage up to 300 km

Forms a ceramic-metal coating on the surfaces of friction pairs (engine parts restore their geometry). As a result, the renewed unit surpasses a new one in terms of its operational characteristics and serves 2–4 times longer.

Detailed specifications


Engine treatment is carried out in three stages:

Stage 1. Introduce the contents of the syringe into the oil filler neck of the engine warmed up to the operating temperature.

Start the engine and idle it for 5–10 minutes. Stage 2 is carried out in the same manner after 100–250 km of run.

Stage 3 is carried out in the same manner after another 100–250 km of run. The treatment is considered completed after at least 1,500 km of run.


  • It is not recommended to change the oil until the end of the treatment.
  • Treatment can be carried out at idle (4 h of idling are equal to 200 km of run).
  • New engines with up to 20,000 km of run should be treated in one stage.
  • Engines after overhaul should be treated in the usual manner in three stages.
  • A protective ceramic-metal coating is formed on any operable mechanism, however, if the mechanism (engine) is in critical condition (100% wear), it is necessary to replace the destroyed parts.

The protective coating remains active for 60,000 km of run; after that, it is recommended to repeat the treatment.


Oil system capacity, L 3-10 11-20 21-30
Number of 8 ml syringes, pcs. 3 6 9
Treatment scheme by stages 1+1+1 2+2+2 3+3+3
Number of syringes for new engines 2 4 6


After the treatment, your car will be under XADO super protection. During engine operation, the cylinder-piston group near the top dead center, parts of the gas distribution mechanism (cam, pusher), and the sliding bearings of the crankshaft and camshaft are most susceptible to wear.

REVITALIZANT® contains building material that compensates for the wear of these parts. As a result of REVITALIZATION®, a new multifunctional gradient coating with a set of necessary performance characteristics and stress states is formed on the surfaces of friction pairs. Engine parts are increasing in volume, returning the very “hundredths” and “tenths” that were lost, worn out during operation. This is XADO repair effect.

The resulting coating has unique properties: significant strength, high corrosion resistance, and low roughness. After REVITALIZATION®, engine parts are guaranteed to serve 2–4 times longer. As a result of the engine REVITALIZATION®, compression in cylinders significantly increases and equalizes; fuel consumption is reduced; car acceleration and coasting improve; oil pumps, turbocharging units, cylinder mirrors, shafts, and liners (bearings) are restored; ovality is eliminated.

The engine runs quietly and without vibration. Thanks to REVITALIZATION®, it can always be maintained in perfect condition.


8 ml syringe in a box, Art. XA 12034_1


There are no reviews yet.

Be the first to review “REVITALIZANT EX120 for All Types of Diesel Engines”

Your email address will not be published. Required fields are marked *